Analog/Trigger Sequencer
Features of the analog rows (knobs):
- 8 potentiometers (knobs)
- lower row: Scale (knob), voltage output range 0 ... ~ +6,5V
- upper row: 1V/2V/4V (octave range switch for exact VCO control), voltage output ranges 0 to 1.0V / 0 to 2.0V / 0 to 4.0V
- Glide time (knob), same as portamento or slew limiter
- Glide Control (control input for switching glide on/off)
- S&H Control (control input for internal S&H, works like A-148)
- Pre Glide/S&H-Out (analog output before S&H and glide unit, especially required when external audio signals are used as inputs of the lower row)
- Post Glide/S&H-Out (analog output after S&H and glide unit)
- Lower row: external inputs for the 8 steps (switched jack sockets), control signals or audio signals may be used as inputs (allowed voltage range -5V...+12V), the knobs of the lower row are working in this case as attenuators.
Features of the trigger rows (switches):
- 4 Trigger/Gate tracks with 2 rows of switches
- Toggle switches of 1-0-1 type (with middle position), which can be used to send a trigger/gate to the track above or below or to send no trigger/gate (middle position)
- 3 trigger rows (i.e. short pulse for each step set, pulse width corresponds to the pulse width of the clock/step input signal)
- 1 gate row (i.e. a high signal is applied during the length of the step set)
Control inputs and buttons:
- Step (defines the tempo of the sequence, same as clock or trigger input)
- Reset (resets all rows to step 1)
- Start (starts the sequence at the momentary position)
- Stop (stops the sequence at the momentary position)